End Table & Ottoman assembly instructions for KITS
Hardware
5. Evenly space slats on bases. (No Glue) You can eye ball placement.  Pick up one slat, apply glue on each end & attach to base base.
Wood Parts List

Glue and assemble apron together using 2 - 13" pre-drilled boards and 2 - 14" boards.  make sure 12 hoes on edge are facing up.  14" boards are on the inside of 13" boards.
32 - 1 5/8" screws
12 - 2 1/2" screws

 

END TABLE Instructions for KITS
3 - 20" x 5 3/8" x 1"
4 - 20" x 2 1/2" x 1"
2 - 14" x 2 1/2" x 1"
2 - 13" x 2 1/2" x 1"
1 - 10" x 2 1/2" x 1"
2 - 9" x 2 1/2" x 1"

4"

3

4

Tools Needed

Apron

5

6

Power Drill with 2" phillips bit
Glue: Small bottle "Titebond All Weather Premium Glue. Home Depot or Lowers
Tape Measure

1

2

10 Turn ottoman over on side and attach two screws in each leg.
Change printer from portrait to "landscape" before printing

Copyright © 2011 Garden Furniture Mill
Parts and Hardware
2 - #1 parts 20" long
2 - #2 left & right legs 10.5" long
7 - #3 16" slats
20 - 1 5/8" screws
Tools
Power Drill w/phillips bit
Buy: small bottle "Titebond II Premium All weather glue
Ottoman Assembly Instructions for KITS
Assemble lower leg brace using 2 - 9" & 1 - 10.5" board. Center 10" board between 2 - 9" pieces.
Glue and attach 4 - 20" legs in the corner of the apron against the 14" boards.  Use 2 screws per leg.
6. Attach slat to bases. Do the same wit each slat one at a time, keeping slats evenly spaced.
2. Position on end of base as shown.

1. Take on slat and apply glue on each end.
3. Fasten each end with screw.

1/8"

Layout: 3 - 20" top boards with the best side down

square

13" Parts

back to product assembly instructions
9 Turn ottoman over and position legs so bottom of legs are flat on floor
8. Screw in middle screw only. Do other leg the same.
7. Glue & attach leg on inside of base. Position leg so there is approx. 1/8" between underside of slats and top of leg.

Back to Links for Product Assembly Instructions

4. Attach slat to other end of bases.  make sure assembly is square.

flat

#2

#1

FINISHED
Attach lower leg brace 4" down from bottom of legs.

3#

Glue and center apron assembly on bottom side of 3 - 20" tops. 13" boards cross over the three tops.  Use 2 1/2" screws to fasten apron to tops.
Next: measure down 4" from bottom of all four legs and mark.